Pick the individual low-profile laser fixture pieces you would like.

These fiber laser fixture pieces are designed to allow easy and repeatable placement of media on your fiber laser bed.  Once the fixtures are attached to your fiber laser bed, they allow you to quickly and consistently place your media without repeated measurements.

Each piece is milled from cast aluminum tool plate and has beautiful shiny faces and sides with chamfered top edges.  Each piece has 6mm holes that are spaced 50mm apart and long slots to allow for maximum flexibility in attaching the fixture pieces to your fiber laser bed.  In addition each interior corner of the "90" and "cross" shaped pieces has been designed with a small recess to allow for your media to fit fully flush into the corner of the fixture piece. 

Pick from the following choices. Price is per group below. 

1 cross shaped piece (55mm arms, 125mm total width)- $9

2 90 shaped pieces (55mm interior length, 67mm exterior length) - $8

1 medium piece (125mm) and 1 long piece (175mm) - $7

2 short pieces (75mm) - $6

No screws are included with these pieces.

Please note that these aluminum pieces are not designed to be fiber lasered.  They can easily be etched by a fiber laser and we are not responsible for any issues/damages that may occur if these pieces are inadvertently lasered.

Full fiber laser fixture kit, also available HERE.  Save $5 when bought as a kit.

All 713Maker.com products are designed and produced in our home-shop here in the USA.