** This batch will ship starting 2-29-2024 **

This fiber laser fixture is designed to allow easy and repeatable placement of business cards on your fiber laser bed.  Once the fixture is attached to your fiber laser bed, it allows you to quickly and consistently place your business cards without repeated measurements.

This is a single piece fixture that is milled from 7075 aluminum and has beautiful shiny faces and sides with chamfered edges.  It has a 3.4in (86.35mm) X 2.13in (54.15mm) X 0.25in (3.25mm) pocket to easily hold a standard business card. The fixture has 2, 6mm pass thru holes that are spaced 50mm apart to allow for easy attachment to your fiber laser bed and once attached, the screws sit just below flush, so your business card will not be scratched or marked by the included, low profile, screws.  There are also 2 extra, threaded, holes on the fixture for convenient screw storage, when the fixture is not in use.  When the screws are placed into the storage holes, they are designed to not pass thru the back of the fixture, so that the fixture will sit flush during storage. The fixture also has a finger grip along each of the four sides for easy access.  These finger grips can also be used as access points when clamps are being used to hold business cards due to heat warping.

Includes:

Fiber laser business card fixture

x2, M6 low profile screws

Please note that this aluminum piece is not designed to be fiber lasered.  It can easily be etched by a fiber laser and we are not responsible for any issues/damages that may occur if the piece is inadvertently lasered.

All 713Maker.com products are designed and produced in our home-shop here in the USA.